LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Master Cylinder Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Master Cylinder
    GM926593Courtesy of GENERAL MOTORS CORP.
  1. Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding .
  2. Install the master cylinder to the brake booster.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the master cylinder mounting nuts.

    Tighten:  Tighten the master cylinder mounting nuts to 25 N.m (18 lb ft).

    4. Fig 2: Disconnecting/Connecting Brake Pipes From Master Cylinder
    GM931327Courtesy of GENERAL MOTORS CORP.
  4. Remove the plugs from the brake pipes.
  5. Connect the brake pipes to the master cylinder.

    Tighten:  Tighten the brake pipe fittings at the master cylinder to 18 N.m (13 lb ft).

    6. Fig 3: Disconnecting/Connecting Brake Fluid Level Sensor Electrical Connector
    GM931316Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connector to the brake fluid level sensor.
  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
scientia non olet · About LEMON Manuals