LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Hose Replacement - Rear >> Removal Procedure

Removal Procedure

    Fig 1: Removing/Installing Brake Flex Hose From Metal Brake Pipe
    GM926801Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Clean all dirt and foreign material from the brake hose ends and brake pipe fittings.
  4. Using a backup wrench on the hose fitting, disconnect the brake pipe fittings from the brake hose. Cap or plug the brake pipe fitting ends and the brake hose ends to prevent fluid loss and contamination.
  5. Remove the brake hose retaining clips from the hose mounting brackets.
  6. Remove the hose from the mounting brackets.
scientia non olet · About LEMON Manuals