LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Hose Replacement - Rear >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Brake Flex Hose From Metal Brake Pipe
    GM926801Courtesy of GENERAL MOTORS CORP.
  1. Install the brake hose to the brake hose mounting brackets. Align the hose fittings with the notch in the brackets.
  2. Install the hose retaining clips onto the hose fittings at the hose brackets.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Using a backup wrench on the hose fitting, connect the brake pipe fittings at the rear brake hose.

    Tighten:  Tighten the fittings to 18 N.m (13 lb ft).

  4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Ensure that the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition.
  6. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals