LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim >> Repair Instructions >> Garnish Molding Replacement - Center Pillar Upper >> Removal Procedure

Removal Procedure

    Fig 1: View Of Shoulder Belt And Components
    GM1650910Courtesy of GENERAL MOTORS CORP.
  1. Unsnap the height adjuster cover.
  2. Remove the D-ring bolt.
  3. Remove the shoulder belt from the center pillar.
    4. Fig 2: Removing Center Pin Of The Garnish Molding Fastener
    GM987721Courtesy of GENERAL MOTORS CORP.
  4. Remove the fastener cover from the center pillar garnish molding by inserting a small flat-bladed tool in the gap at the forward vertical side of the cover.
  5. Remove the center pin of the garnish molding fastener by using needle-nose pliers.
  6. Starting at the top, gently pull on the garnish molding to disengage the attaching clips.
    7. Fig 3: Removing/Installing Fastener Cover To The Garnish Molding
    GM977195Courtesy of GENERAL MOTORS CORP.
  7. Remove the garnish molding by sliding the molding up and disengaging the inside clips from the lower garnish molding.
scientia non olet · About LEMON Manuals