Front Suspension

Wheel Bearing/Hub Replacement - Front

Removal Procedure





1. Remove the front brake rotor.





2. Disconnect the wheel speed sensor electrical connector, if equipped.





3. Remove the wheel speed sensor electrical connector form the connector bracket.





4. Remove the front wheel drive shaft spindle nut.





5. Support the wheel drive shaft with heavy mechanic's wire or equivalent.
6. Remove and discard the wheel bearing/hub mounting bolts.
7. Remove the wheel bearing/hub assembly from the steering knuckle.

Installation Procedure





1. Install the wheel bearing/hub assembly to the steering knuckle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the wheel bearing/hub mounting bolts.
^ Tighten the bolts to 130 Nm (96 ft. lbs.).





3. Install the wheel drive shaft spindle nut.
^ Tighten the nut to 205 Nm (151 ft. lbs.).





4. Install the wheel speed sensor electrical connector to the mounting bracket, if equipped.





5. Connect the wheel speed sensor electrical connector.





6. Install the front brake rotor.