Brake Light Switch: Adjustments

STOP LAMP SWITCH ADJUSTMENT

ADJUSTMENT PROCEDURE




1. Disconnect the electrical connector from the stop lamp switch.

NOTE: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment may cause brake drag, heat buildup and excessive brake lining wear.




2. Rotate the switch counterclockwise and remove the switch from the switch retainer.
3. Install the switch to the bracket by turning and pushing the switch until the switch bottoms on the brake pedal.

IMPORTANT: Do NOT depress the brake pedal assembly during the stop lamp switch installation. This will cause a drag condition on the brake.

4. Connect the electrical connector to the stop lamp switch.
5. Inspect the stop lamps for proper operation