Powertrain Mount Balance - Total Mounts

Powertrain Mount Balance Procedure - Total Mount

Important: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.

1. Raise and support the vehicle.





2. Loosen the front mount through bolt. Do not remove.





3. Loosen the rear mount through bolt. Do not remove.
4. Position two floor jacks with wood blocks under the engine and transmission to support the powertrain assembly.





5. From the engine compartment, loosen, do not remove the LH mount bolts.





6. Loosen, do not remove the RH mount bolts.
7. Reposition the floor jacks to allow a 1/8 in gap between the mount and mount bracket





Notice: Refer to Fastener Notice in Service Precautions.

8. ^ Tighten the LH mount starting with the center bolt.
^ Tighten the bolts to 50 Nm (37 ft. lbs.).





9. Tighten the RH mount starting with the center bolt.
^ Tighten the bolts to 50 Nm (37 ft. lbs.).
10. Remove the floor jacks.
11. Shake the powertrain Vigorously from front to rear and allow the powertrain to settle.





12. Tighten the rear mount through bolt.
^ Tighten the bolts to 110 Nm (81 ft. lbs.).





13. Tighten the front mount through bolt.
^ Tighten the bolts to 110 Nm (81 ft. lbs.).
14. Lower the vehicle.