Rear Door Striker: Service and Repair

Door Striker Replacement - Rear Door

Removal Procedure

Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.




1. Using a grease pencil, mark around the striker for installation purposes.
2. Remove the screws.
3. Remove the striker.

Installation Procedure




1. Install the striker loosely with the bolts.
2. Align the striker with the marks made prior to removal.
3. Tighten the bolts.
4. Inspect the door closing and align the striker as required.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Tighten the striker bolts.

Tighten the door striker bolts to 25 Nm (18 lb ft).