Fixed Antenna Replacement

FIXED ANTENNA REPLACEMENT

REMOVAL PROCEDURE
1. Remove the front fender.




2. Pull to remove the antenna mast bezel.




3. Remove the antenna mast from the antenna base by turning counterclockwise.
4. Disconnect the antenna lead-in from the antenna base.




5. Remove the antenna base fasteners from the bracket on the antenna base.
6. Remove the antenna base.

INSTALLATION PROCEDURE




1. Connect the antenna lead-in to the antenna base.




2. Install the antenna base.
3. Install the screws to the bracket on the antenna base.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 10 N.m (89 lb in).




4. Install the antenna bezel.
5. Install the antenna mast to the antenna base by turning clockwise.

Tighten the mast to 10 N.m (89 lb in).

6. Install the front fender.