Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0053, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0125, P0128, P0131, P0132, P0133, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0464, P0496, P1133, P1134, P2135 are not set.
The Engine Run Time parameter is at least 3 minutes.
The traction control, if equipped, is not active.
The PCM is not commanding Power Enrichment or Decel Fuel Cutoff modes.
The MAF Sensor parameter is between 8-38 g/s.
The Engine Speed parameter is between 602-3,000 RPM.
The TP Indicated Angle parameter is between 3-35 percent.
The ECT Sensor parameter is at least 65°C (149°F).
The system voltage is between 9-18 volts.
The Catalytic Converter Protection Active parameter is NO
The above conditions have been met for 3 seconds.