Circuit Description
WARNING: This page is about a different variant/trim than selected.
The accelerator pedal position (APP) sensor 2 is a potentiometer type sensor with the following 3 circuits:
- A 5-volt reference circuit
- A low reference circuit
- A signal circuit
The control module provides the APP sensor a 5-volt reference circuit and a low reference circuit. The APP sensor then provides the control module a signal voltage proportional to pedal movement. The APP sensor 2 signal voltage is low at rest and increases as the pedal is depressed. When the control module detects that the APP sensor 2 signal or the APP sensor 5-volt reference voltage is outside the predetermined range, DTC P2125 sets.