LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls - 3.5L - DTC P0220 To DTC P0455) >> DTC P0315 >> Conditions for Clearing the MIL/DTC

Conditions for Clearing the MIL/DTC

WARNING: This page is about a different variant/trim than selected.
DTC P0315

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
IMPORTANT: The Crankshaft Position (CKP) Variation Learn procedure may need to be repeated up to 5 times before the powertrain control module (PCM) learns the variation.
Perform the CKP System Variation Learn procedure. Refer to Crankshaft Position System Variation Learn .Does the scan tool display Learned this ignition?
Go to Step 4  Go to Step 3 
3 Inspect for the following conditions:
  • Electromagnetic interference in the signal circuit of the CKP sensor
  • The ignition switch is in the ON position until the battery has insufficient system voltage.
  • A PCM power disconnect with the ignition ON may erase the stored value and set the DTC P0315.
  • Debris between the CKP sensor and the reluctor wheel

Did you complete the inspection?
Go to Step 4  -
4
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?
Go to Step 2  Go to Step 5 
5 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?
Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK