Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0016, P0101, P0102, P0103, P0107, P0108, P0116, P0117, P0118, P0120, P0125, P0128, P0220, P0315, P0335, P0336, P0340, P0341, P0608, P1125, P1516, P2101, P2108, P2120, P2125, P2135, or P2138 is not set.
The engine speed is between 525-5,700 RPM.
The ignition voltage is between 9-18 volts.
The engine coolant temperature (ECT) is between -7 and +123°C (+19 and +253°F).
If the ECT is less than -7°C (+19°F) at engine start-up, the diagnostic will be disabled until the ECT is more than 21°C (69°F).
The fuel level is more than 10 percent.
The ABS and the traction control system (TCS) are not active.
The transmission is not changing gears.
The PCM is not in fuel shut-off or decel fuel cut-off mode.
The PCM is not receiving a rough road signal.
The power management is not active.
Excessive drive wheel slip is not detected.