Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0125, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0464, P0496, P2135, P2A01 are not set.
DTCs P0401, P0420, and P2A01 are not commanding fuel.
The system voltage is between 9-18 volts.
The scan tool special functions are not active.
The Engine Run Time parameter is at least 100 seconds.
The ECT parameter is at least 65°C (149°F).
The MAF Sensor parameter is between 4-30 g/s.
The Engine Speed parameter is between 600-3,000 RPM.
The above conditions have been met for at least 3 seconds.