Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0125, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0464, P0496, P2135, P2A00 are not set.
DTC P0401, P0420, and P2A01 are not commanding fuel.
The system voltage is between 9-18 volts.
The scan tool special functions are not active.
The TP sensor parameter is between 3-40 percent.
The Air Fuel Ratio parameter is between 12:1-16.5:1.
The loop status parameter is closed.
The above conditions must be met for at least 3 seconds.