Circuit/System Testing: P0117

Ignition ON, engine OFF, disconnect the ECT sensor and observe the ECT parameter for -38°C (-36°F).

• If over -38°C (-36°F), test the signal circuit of the ECT sensor for a short to ground, a short to any low reference circuit. If the ECT circuits check OK, replace the ECT sensor.
• If under -38°C (-36°F), test for an intermittent and a poor connection at the ECT sensor. If the ECT circuits check OK, replace the control module.

P0118

1. With the ignition ON, engine OFF, disconnect the ECT sensor and measure for 4.8-5.2 volts from the signal circuit of the ECT sensor to a good ground with a DMM.
   • If over 5.2 volts, test the ECT signal circuit for a short to voltage, an intermittent and a poor connection at the control module. If all test OK, replace the control module.
   • If under 4.8 volts, test the signal circuit of the ECT sensor for high resistance, an open, or a short to any 5-volt reference circuit.
2. With the ignition ON, engine OFF
3. Connect a 3-amp jumper wire between the signal circuit of the ECT sensor and the low reference circuit.
4. Observe the ECT parameter with a scan tool for 139°C (282°F).
   • If more than the specified value, test the ECT signal circuit for a short to any 5-volt reference circuit, or a faulty connection at control module. If circuits test OK, replace the ECT sensor.
5. Connect a 3-amp jumper wire between the signal circuit of the ECT sensor and a good ground.
6. Observe the ECT parameter with a scan tool for 139°C (282°F).
   • If more than the specified value, test the ECT low reference circuit for high resistance or an open. Test for a faulty connection at the control module or a faulty control module. If the circuit tests OK, replace the control module.

P1114 or P1115

1. Observe the ECT sensor parameter on the scan tool, while moving the ECT sensor connector and the control module connector. Is there an abrupt change indicated on the scan tool?
   • If change, then repair the connector or terminal as necessary.
   • If no change, observe the ECT sensor parameter on the scan tool, while moving the wiring harness at the ECT sensor and the control module. If there is a change on the scan tool, then repair the wiring as necessary.
2. If everything checks out, then refer to Testing for Intermittent Conditions and Poor Connections .