Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0112
- DTCs P0116, P0117, P0118, P0125, P0128, P0502, P0503 are not set.
- The engine run time is more than 10 seconds.
- The vehicle speed sensor (VSS) indicates that vehicle speed is more than 40 km/h (25 mph).
- The engine coolant temperature (ECT) is less than 121°C (250°F).
- The diagnostic runs continuously when the above conditions are met.
P0113
- DTCs P0101, P0102, P0103, P0116, P0117, P0118, P0125, P0128, P0502, P0503 are not set.
- The engine run time is more than 180 seconds.
- The VSS indicates that vehicle speed is less than 24 km/h (15 mph).
- The mass air flow (MAF) is less than 10 g/s.
- The ECT is more than 60°C (140°F).
- The diagnostic runs continuously when the above conditions are met.
P1111
- DTCs P0101, P0102, P0103, P0116, P0117, P0118, P0125, P0128, P0502, P0503 are not set.
- The engine run time is more than 180 seconds.
- The ECT sensor parameter is more than 60°C (140°F).
- The vehicle speed is less than 24 km/h (15 mph).
- The MAF is less than 10 g/s.
- The diagnostic runs continuously when the above conditions are met.
P1112
- DTCs P0116, P0117, P0118, P0125, P0128, P0502, P0503 are not set.
- The engine run time is more than 10 seconds.
- The ECT sensor parameter is less than 121°C (250°F).
- The VSS indicates that vehicle speed is more than 40 km/h (25 mph).
- The diagnostic runs continuously when the above conditions are met.