Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0107
- The control module detects that the MAP sensor voltage is less than 0.1 volt for more than 3 seconds.
- This diagnostic runs continuously.
P0108
- The control module detects that the MAP sensor voltage is more than 4.3 volts for more than 3 seconds.
- This diagnostic runs continuously.
P1106
- The control module detects that the MAP sensor voltage is intermittently more than 4.3 volts.
- This diagnostic runs continuously.
P1107
- The control module detects that the MAP sensor voltage is intermittently less than 0.1 volt.
- This diagnostic runs continuously.