Removal Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Cautions and Notices.

Fig 1: View Of Quick-Connect Fitting Retainer (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

Relieve the fuel system pressure before servicing any fuel system connection. Refer to the Fuel Pressure Relief .
Remove the retainer from the quick-connect fitting.

Fig 2: Blowing Dirt Out Of Fitting (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Notice in Cautions and Notices.

CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.

Fig 3: Releasing Quick Connect Locking Tabs (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

Choose the correct tool from the J 37088-A for the size of the fitting. See Special Tools . Insert the tool into the female connector, then push inward in order to release the locking tabs.

Fig 4: Releasing Quick Connect Locking Tabs (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Relieving Fuel Pressure Caution in Cautions and Notices.

Pull the connection apart.
Use a clean shop towel in order to wipe off the male pipe end.
Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.