LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnecting/Reconnecting Manifold Absolute Pressure (MAP) Sensor Electrical Connector
    GM1544767Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (2).
    2. Fig 2: Identifying MAP Sensor Retaining Bolt & Bracket
    GM1544765Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor retaining bolt (3) and bracket (2).
  3. Remove the MAP sensor (1) and the MAP sensor port seal if it is still retained in the intake manifold.
scientia non olet · About LEMON Manuals