LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing 4 Screws Securing Ignition Coil And Module Assembly To Bracket
    GM1238999Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil and module assembly to the bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the ignition coil and module assembly screws.

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Connect the spark plug wires as noted during the removal.
  4. Connect the brake booster vacuum hose from the intake manifold.
scientia non olet · About LEMON Manuals