LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Replacement (Long Wheel Base) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Fuel Tank And EVAP Components
    GM1544795Courtesy of GENERAL MOTORS CORP.
  1. Place the fuel tank in a suitable work area.
  2. Remove the EVAP canister (2). Refer to Evaporative Emission Canister Replacement (Long Wheel Base)  or Evaporative Emission Canister Replacement (Short Wheel Base) .
  3. Remove the EVAP canister vent valve (3). Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement (Short Wheel Base)  or Evaporative Emission Canister Vent Solenoid Valve Replacement (Long Wheel Base) .
  4. Remove the fuel sender assembly (4). Refer to Fuel Sender Assembly Replacement (Short Wheel Base)  or Fuel Sender Assembly Replacement (Long Wheel Base) .
  5. Remove the fuel feed pipe (1) from the fuel tank pipe clips.
  6. Remove the EVAP purge pipe (6) from the fuel tank pipe clip.
scientia non olet · About LEMON Manuals