LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Replacement (Long Wheel Base) >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Fuel Tank And EVAP Components
    GM1544795Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP purge pipe (6) into the fuel tank clip.
  2. Install the fuel feed pipe (1) into the fuel tank pipe clips.
  3. Install the fuel sender assembly (4). Refer to Fuel Sender Assembly Replacement (Short Wheel Base)  or Fuel Sender Assembly Replacement (Long Wheel Base) .
  4. Install the EVAP canister vent valve (3). Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement (Short Wheel Base)  or Evaporative Emission Canister Vent Solenoid Valve Replacement (Long Wheel Base) .
  5. Install the EVAP canister (2). Refer to Evaporative Emission Canister Replacement (Long Wheel Base)  or Evaporative Emission Canister Replacement (Short Wheel Base) .
scientia non olet · About LEMON Manuals