LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Level Sensor
    GM1544791Courtesy of GENERAL MOTORS CORP.
  1. Slide the NEW sensor up along the bucket until the retainer (2) is engaged.
  2. Connect the fuel level sensor electrical connector (1) under the cover.
  3. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement (Short Wheel Base)  or Fuel Sender Assembly Replacement (Long Wheel Base) .
scientia non olet · About LEMON Manuals