LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Evaporative Emission (EVAP) Canister Purge Solenoid Valve
    GM1544746Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
  2. Disconnect the electrical connector (1) from the exhaust gas recirculation (EGR) valve (2).
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the transaxle fill tube bolt to the transaxle case.
  5. Remove the transaxle fill tube nut at the EGR valve and reposition the fill tube.
  6. Lower the vehicle.
    7. Fig 2: Removing/Installing EGR Valve
    GM1239053Courtesy of GENERAL MOTORS CORP.
  7. Remove the EGR pipe bolt and carefully pull the pipe assembly back.
  8. Remove the EGR valve bolts.
  9. Remove EGR valve.
  10. Remove the EGR valve gasket.
  11. Clean and inspect the EGR valve gasket mating surfaces.
scientia non olet · About LEMON Manuals