LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Canister/Fuel Tank (Long Wheel Base) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Long Wheel Base)  or Fuel Tank Replacement (Short Wheel Base) .
    2. Fig 1: Locating Fuel Tank And EVAP Components
    GM1544795Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) canister purge pipe (6) from the EVAP canister (2).
  3. Remove the EVAP canister purge pipe from the fuel tank retainer.
  4. Disconnect the EVAP canister vent solenoid pipe from the EVAP canister (2) and EVAP canister vent solenoid (3).
  5. Remove the EVAP canister vent solenoid pipe from the fuel tank.
  6. Disconnect the EVAP pipe assembly from the EVAP canister (2) and fuel sender module (4).
  7. Remove the EVAP pipe assembly from the fuel tank.
scientia non olet · About LEMON Manuals