LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Canister/Fuel Tank (Long Wheel Base) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Fuel Tank And EVAP Components
    GM1544795Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP pipe assembly to the fuel tank.
  2. Connect the EVAP pipe assembly to the EVAP canister (2) and fuel sender module (4).
  3. Install the EVAP canister vent solenoid pipe to the fuel tank.
  4. Connect the EVAP canister vent solenoid pipe to the EVAP canister (2) and EVAP canister vent solenoid (3).
  5. Install the EVAP canister purge pipe (6) into the fuel tank retainer.
  6. Connect the EVAP canister purge pipe (6) to the EVAP canister (2).
  7. Install the fuel tank. Refer to Fuel Tank Replacement (Long Wheel Base)  or Fuel Tank Replacement (Short Wheel Base) .
scientia non olet · About LEMON Manuals