LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (Long Wheel Base) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Long Wheel Base)  or Fuel Tank Replacement (Short Wheel Base) .
    2. Fig 1: Locating Fuel Tank And EVAP Components
    GM1544795Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical harness (5) from the evaporative emission (EVAP) canister vent solenoid valve (3).
  3. Disconnect the EVAP vent hose from the EVAP canister vent solenoid valve (3).
  4. Release the lock tab on the EVAP canister vent solenoid valve bracket and remove the EVAP canister vent solenoid valve (3).
scientia non olet · About LEMON Manuals