LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (Long Wheel Base) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Fuel Tank And EVAP Components
    GM1544795Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid valve (3) on the EVAP canister vent solenoid valve bracket. Pull on the valve to ensure retaining tab is locked.
  2. Connect the EVAP vent hose to the EVAP canister vent valve.
  3. Connect the EVAP canister vent valve electrical harness connector (5).
  4. Install the fuel tank. Refer to Fuel Tank Replacement (Long Wheel Base)  or Fuel Tank Replacement (Short Wheel Base) .
scientia non olet · About LEMON Manuals