LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement (Short Wheel Base) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Identifying Fuel Tank And Related Components
    GM1544794Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) vent hose, purge pipe (6), and vapor pipe from the EVAP canister (1).
  3. Remove the forward attaching nut from the EVAP canister bracket.
  4. Remove the two rear attaching nuts from the EVAP canister bracket at the fuel tank.
  5. Lower the EVAP canister assembly.
  6. Pull the rear canister bracket flange away from the EVAP canister.
  7. Lift the rear of the EVAP canister from the bracket to release the forward tab.
scientia non olet · About LEMON Manuals