LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement (Short Wheel Base) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the EVAP canister into the forward tab of the canister bracket.
  2. Press the rear of the EVAP canister down in order to engage the rear bracket tabs.
    3. Fig 1: Identifying Fuel Tank And Related Components
    GM1544794Courtesy of GENERAL MOTORS CORP.
  3. Install the EVAP canister assembly to the fuel tank.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the two attaching nuts to the EVAP canister bracket at the fuel tank studs.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  5. Install the forward attaching nut to the canister bracket.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  6. Connect the EVAP vent hose, purge pipe (6), and vapor pipe to the EVAP canister (1).
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals