LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Evaporative Emission (EVAP) Canister Purge Solenoid Valve
    GM1544746Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (6) from the evaporative emission (EVAP) canister purge valve (5).
  2. Disconnect the EVAP canister purge pipe from the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: View Of EVAP Canister Purge Valve & Gasket
    GM1544892Courtesy of GENERAL MOTORS CORP.
  3. Remove the EVAP canister purge valve bolt (1).
  4. Remove the EVAP canister purge valve (3) and gasket (2) from the intake manifold.
scientia non olet · About LEMON Manuals