LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Purge Valve & Gasket
    GM1544892Courtesy of GENERAL MOTORS CORP.
  1. Position the EVAP canister purge valve (3) and gasket (2) to the intake manifold.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP canister purge valve bolt (1).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Evaporative Emission (EVAP) Canister Purge Solenoid Valve
    GM1544746Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister purge pipe to the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Connect the electrical connector (6) to the EVAP canister purge valve (5).
scientia non olet · About LEMON Manuals