LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Remove the power steering pump. Refer to Power Steering Pump Replacement .
  3. Disconnect the camshaft position (CMP) sensor electrical connector.
  4. Remove the attaching bolt.
  5. Remove the CMP sensor.
  6. Inspect the CMP sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals