LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the O-ring with clean engine oil. Replace the O-ring if the O-ring is damaged.
    2. Fig 1: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the CMP sensor.

    Tighten:  Tighten the retaining bolt to 8 N.m (71 lb ft).

  3. Connect the CMP sensor electrical connector.
  4. Install the power steering pump. Refer to Power Steering Pump Replacement .
scientia non olet · About LEMON Manuals