LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the insulator panel. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel .
  2. Remove the electrical connector position assurance (CPA) clip.
    3. Fig 1: Removing/Installing Accelerator Pedal Position Sensor
    GM1544734Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the accelerator pedal position sensor electrical connector.
  4. Remove the accelerator mounting bolts (1) from the accelerator bracket.
  5. Remove the accelerator assembly (2) from the vehicle.
scientia non olet · About LEMON Manuals