LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Valve Rocker Arm and Push Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Valve Rocker Arm
    GM54392Courtesy of GENERAL MOTORS CORP.
  1. Install the pushrods in the original location.
    • Coat the ends of the pushrods with lubricant. Refer to Sealers, Adhesives, and Lubricants  for the 3.5L engine.
    • The intake pushrods are identified with yellow stripes and are 5 3/4 inches long.
    • Exhaust pushrods are identified with green stripes and are 6 inches long.
    • Ensure that the pushrods seat in the lifter.
  2. Install the rocker arms.
    3. NOTE: Refer to Fastener Notice .
  3. Install the rocker arm bolts.

    Tighten:  Tighten the rocker arm bolts to 32 N.m (24 lb ft).

  4. Install the valve rocker covers. Refer to Valve Rocker Arm Cover Replacement - Left Side  or Valve Rocker Arm Cover Replacement - Right Side .
scientia non olet · About LEMON Manuals