Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of PCV Baffle, Screws, PCV Valve & Valve Cover

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

If the PCV valve was cleaned:
1. Install the PCV baffle (2).
2. Install the PCV baffle screws (1).
  Tighten: Tighten the screws to 6 N.m (53 lb in).

Fig 2: View Of Valve Rocker Arm Cover - Left

Courtesy of GENERAL MOTORS CORP.

Install the left valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left Side .