LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Rotate the oil pump drive shaft as necessary in order to obtain the engagement with the oil pump drive unit.
    Fig 1: Removing/Installing Oil Pump & Oil Pump Drive Shaft
    GM190530Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump drive shaft and the oil pump.
    2. NOTE: Refer to Fastener Notice .
  2. Install the oil pump bolt.

    Tighten:  Tighten the bolt to 41 N.m (30 lb ft).

  3. Install the oil pan. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals