LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Engine Support Fixture >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the right engine mount strut. Refer to Engine Mount Strut Replacement - Left Side .
    2. Fig 1: View Of J 45057
    GM759952Courtesy of GENERAL MOTORS CORP.
  2. Install the J 45057  to the right engine mount strut bracket (1). See Special Tools .
    3. Fig 2: Installing J 45057 To Left Side Engine Lift Bracket
    GM759950Courtesy of GENERAL MOTORS CORP.
  3. Install the J 45057  to the left side engine lift bracket. See Special Tools .
    4. Fig 3: View of J 45057 Installed To Right Side Engine Lift Bracket
    GM759951Courtesy of GENERAL MOTORS CORP.
  4. Install the J 45057  to the right rear engine lift bracket. See Special Tools .
  5. Open and secure the hood in a 90 degree position.
    6. Fig 4: Identifying J 28467-B & J 28467-3
    GM790666Courtesy of GENERAL MOTORS CORP.
  6. Install a J 28467-B  and retention pin to each end of the J 28467-500  beam (2). See Special Tools .
    7. Fig 5: View Of Engine Lift Bracket
    GM105924Courtesy of GENERAL MOTORS CORP.
  7. Position the J 28467-B  to the left and right side inner fender rails in order to install the J 28467-500  . See Special Tools .
    8. Fig 6: View Of Lift Hook Assembly
    GM682139Courtesy of GENERAL MOTORS CORP.
  8. Assemble the following to create 2 lift hook assemblies as shown:
    9. Fig 7: View Of Lift Hook & Bracket Assembly At Longitudinal Mounted Cross Bar
    GM682301Courtesy of GENERAL MOTORS CORP.
  9. Install the 2 lift hook assemblies (1) to the J 45057-2  (2). See Special Tools .
    10. Fig 8: View Of Right Side Lift Hook Assembly
    GM759954Courtesy of GENERAL MOTORS CORP.
  10. Install the right side lift hook assembly to the right side hole in the J 45057  (2). See Special Tools .
    11. Fig 9: View Of Left Side Lift Hook Assembly
    GM759953Courtesy of GENERAL MOTORS CORP.
  11. Install the left side lift hook assembly to the left side hole in the J 45057  (2). See Special Tools .
  12. Gently tighten the J 28467-34  lift hook wing nuts. See Special Tools .
  13. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  14. Remove the lower air baffle. Refer to Radiator Air Baffle Assemblies and Deflectors .
  15. Install one end of a suitable utility strap to the transaxle.
    • If the vehicle is equipped with All Wheel Drive (AWD), carefully wrap the utility strap around the transfer case.
    • If the vehicle is equipped with Front Wheel Drive (FWD), carefully wrap the utility strap around the transaxle case extension housing.
  16. Install the opposite end of the utility strap to a suitable underbody structure.
  17. Tighten the utility strap in order to prevent movement of the powertrain.
scientia non olet · About LEMON Manuals