LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Engine Oil Cooler Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Upper Oil Cooler Outlet Hose
    GM741937Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the upper oil cooler outlet hose from the thermostat bypass pipe.
  2. Disconnect the lower oil cooler outlet hose from the oil cooler.
  3. Remove the oil cooler outlet hoses and pipe.
    4. Fig 2: View Of Oil Cooler Connector
    GM190502Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil cooler connector.
    5. Fig 3: View Of Oil Cooler Inlet Hose Clamp & Oil Cooler
    GM190501Courtesy of GENERAL MOTORS CORP.
  5. Remove the oil cooler inlet hose clamp and oil cooler.
    6. Fig 4: View Of Oil Cooler Inlet Hose Clamp & Oil Cooler Inlet Hose
    GM190500Courtesy of GENERAL MOTORS CORP.
  6. Remove the oil cooler inlet hose and oil cooler inlet hose clamp from the oil cooler hose fitting.
    7. Fig 5: Locating Oil Cooler Hose Fitting
    GM190499Courtesy of GENERAL MOTORS CORP.
  7. Remove the oil cooler hose fitting.
scientia non olet · About LEMON Manuals