LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Engine Mount Strut Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount Strut Bracket Bolts
    GM61845Courtesy of GENERAL MOTORS CORP.
  1. Install the left engine mount strut bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount strut bracket bolts through the engine mount strut bracket to the cylinder head.

    Tighten:  Tighten the engine mount strut bracket bolts to 70 N.m (52 lb ft).

  3. Install the thermostat housing. Refer to Engine Coolant Thermostat Replacement (RPO LX9) or Engine Coolant Thermostat Replacement (RPO LZ9) in Engine Cooling.
    4. Fig 2: Locating Bolt & Nut For Engine Mount Strut At Left Engine Mount Strut Bracket
    GM105883Courtesy of GENERAL MOTORS CORP.
  4. Install the left engine mount strut to the left engine mount strut bracket. Refer to Engine Mount Strut Replacement - Left Side .
scientia non olet · About LEMON Manuals