Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Holding Flywheel

Courtesy of GENERAL MOTORS CORP.

Install the flywheel and the flywheel retainer.
Use the J 43442 to secure the flywheel in order to prevent the crankshaft from rotating. See Special Tools .

Fig 2: Identifying Engine Flywheel & Components

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the engine flywheel bolts.
Tighten: Tighten the bolts to 71 N.m (52 lb ft).
Measure the flywheel runout:
1. Install a dial indicator on the engine block and inspect the engine flywheel runout at 3 attaching bosses. Refer to Engine Mechanical Specifications .
2. If the condition cannot be corrected, replace the engine flywheel.
Install the automatic transaxle. Refer to Transmission Replacement (M15) or Transmission Replacement (M76) in Automatic Transaxle - 4T40-E/4T45-E.