LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
    2. Fig 1: Removing Crankshaft Rear Oil Seal
    GM55077Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not nick the crankshaft sealing surface when removing the seal.
  2. Remove the crankshaft rear oil seal.
    1. Insert a flat-bladed tool or similar tool through the dust lip at an angle.
    2. Pry the crankshaft rear oil seal out by moving the handle of the tool towards the end of the crankshaft.
    3. Repeat, as necessary, around the crankshaft rear oil seal.
scientia non olet · About LEMON Manuals