Valve Rocker Arm Cover Removal - Left Side
WARNING: This page is about a different variant/trim than selected.
- Remove the positive crankcase ventilation (PCV) tube bolt and clip.
- Remove the PCV tube.
- Remove the valve rocker arm cover bolts.
- Remove the valve rocker arm cover.
- Trim valve cover gasket and sealant away from lower intake manifold gasket at the cylinder head to lower intake manifold joints (1).
- Remove the valve rocker arm cover gasket.
NOTE:
Valve rocker arm cover gasket and sealant must be carefully trimmed away from lower intake manifold gasket. Failure to do so will damage the lower intake manifold gasket, causing a severe oil leak.
IMPORTANT:
When removing the valve rocker arm cover make sure the gasket stays in place attached to the cylinder head.