LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Upper Intake Manifold Removal

Upper Intake Manifold Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing Upper Intake Manifold And Components
    GM909590Courtesy of GENERAL MOTORS CORP.
  1. Remove the connector from manifold absolute pressure (MAP) sensor.
  2. Remove the exhaust gas recirculation (EGR) bolts.
  3. Remove the EGR.
  4. Remove the upper intake manifold bolts or studs.
  5. Remove the upper intake manifold and gaskets.
scientia non olet · About LEMON Manuals