Oil Pump Installation
WARNING: This page is about a different variant/trim than selected.
- Install the oil pump.
- Position the oil pump onto the pins.
- Install the oil pump bolt attaching the oil pump to the rear crankshaft bearing cap.
Tighten: Tighten the oil pump bolt to 41 N.m (30 lb ft).
- Install the crankshaft oil deflector.
- Install the crankshaft oil deflector nuts.
Tighten: Tighten the crankshaft oil deflector nuts to 25 N.m (18 lb ft).
NOTE:
Refer to Fastener Notice
.