LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Oil Level Indicator and Tube Removal

Oil Level Indicator and Tube Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Thermostat Bypass Pipe Hose And Thermostat Bypass Pipe
    GM909552Courtesy of GENERAL MOTORS CORP.
  1. Remove the thermostat bypass pipe hose from the thermostat bypass pipe.
    2. IMPORTANT: Passenger cars will have a 16 pin connector attached to the bypass pipe. Passenger vans will have the connector attached to the drive belt shield.
  2. Remove the 16 pin connector.
  3. Remove the spark plug wires from the spark plugs and set aside.
  4. Remove the spark plug wire clip from the pipe.
  5. Remove the oil cooler hose if applicable.
  6. Remove the heated oxygen sensor connector from pipe.
  7. Remove the thermostat bypass pipe to throttle body nuts.
  8. Remove the thermostat bypass pipe to throttle body bolt.
  9. Remove the thermostat bypass pipe to engine front cover bolt.
  10. Remove the thermostat bypass pipe.
    11. Fig 2: Removing/Installing Oil Level Indicator Tube Bolt
    GM909555Courtesy of GENERAL MOTORS CORP.
  11. Remove the oil level indicator tube bolt.
  12. Remove the oil level indicator and oil level indicator tube.
scientia non olet · About LEMON Manuals