Crankshaft Balancer Removal

Tools Required

• J 41816-A  Crankshaft Balancer Remover
• EN 46359  Puller End Protector. See Special Tools .

Fig 1: Removing/Installing Crankshaft Balancer Bolt And Washer
Courtesy of GENERAL MOTORS CORP.
1. Remove the crankshaft balancer bolt and washer.
Fig 2: Removing Crankshaft Balancer
Courtesy of GENERAL MOTORS CORP.
NOTE: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.
2. Remove the crankshaft balancer using the J 41816-A  along with EN 46359  or equivalent. See Special Tools .