Camshaft Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Camshaft Position Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the camshaft position sensor bolt.
Remove the camshaft position sensor.

Fig 2: View Of Camshaft Thrust Plate

Courtesy of GENERAL MOTORS CORP.

Remove the camshaft thrust plate screws.
Remove the camshaft thrust plate.

Fig 3: Inspecting Camshaft Journals

Courtesy of GENERAL MOTORS CORP.

NOTE: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.

Complete the following steps in order to remove the camshaft.
1. Install the camshaft sprocket bolt into the camshaft. Tighten finger tight only.
2. Carefully rotate and remove the camshaft from the engine block.